I have a Innovate WB LM1,and a Apexi PFC.

I want to install the WB sensor in the M2 Dp ,O2 sensor hole.
I have searched and found out that this can be done. Especially with a M2 downpipe since the stock o2 sensor is a little lower compared to other DP which i have.

I also have a apexi with commander going in also. From what i read you can have the WB work as a Narrowband and a Wideband. But all the post i've read, most are talking about the apexi data logger hooked up with it also. Can this set up work with just the WB and Apexi PFC.

How do i wire this up to work. My WB has the sensor that hook up to the hand controller and a power cord that's it. It does have some other inputs on it. Do i need a additional wire that hooks up to the WB o2 sensor to the apexi.

Not sure of what needs to be down for installation and to configure it to work as a NB and WB at the same time? thanks

 

Anybody have this setup?

 

In short, yes. The LM-1 has a programmable analog output that can set to provide a narrow band O2 sensor output. The instructions with the LM-1 go into detail on how to set it up.

Paul