13bre converting to stick ?s
08-24-05, 08:58 PM
#1
the rxzero
Thread Starter
Join Date: Dec 2003
Location: allentown PA
Posts: 363
Likes: 0
Received 0 Likes
on
0 Posts
13bre converting to stick ?s
I have a jdm 13bre and want to convert it to manual .I have a tt trans on the way but will a 3rd gen flywheel and counterbalance work ?also what clutch should I run act, exedy, centerforce I will be running a microtech no smog water injection no sequence maybe single turbo and very little exaust .this will be in a 4x4 arena race truck which will weigh @ 2400lbs.thanks My goal is 400hp or more any tips to make that happen would also be apprecatied
08-25-05, 08:01 AM
#3
Tequila? ..it's like beer
iTrader: (1)
Join Date: Mar 2001
Location: Woodbine, MD
Posts: 1,124
Likes: 0
Received 0 Likes
on
0 Posts
Yep. Leave the auto-counter balance on and any aftermarket flywheel will bolt right up. Take the auto-counterweight off and you can bolt on the stock manual flywheel.
Centerforce doesn't have the best rep with the 3rd gen crowd. You tend to see a lot of ACT recommended around here. The either heavier ACT pressure plate would be fine for a street car at that power level but I'm sure you'll probably have different requirements.
Centerforce doesn't have the best rep with the 3rd gen crowd. You tend to see a lot of ACT recommended around here. The either heavier ACT pressure plate would be fine for a street car at that power level but I'm sure you'll probably have different requirements.
Thread
Thread Starter
Forum
Replies
Last Post
