RX7Club.com - Mazda RX7 Forum

3rd Gen General Discussion The place for non-technical discussion about 3rd Gen RX-7s or if there's no better place for your topic

FD crank to trigger wheel positioning

Thread Tools
 
Search this Thread
 
Old Dec 10, 2025 | 10:15 PM
Share
  #1  
cardmarc's Avatar
cardmarc
Thread Starter
Full Member
Liked
Loved
Community Favorite
 
Joined: Nov 2001
Posts: 162
Likes: 4
From: Dallas/Denton, TX
FD crank to trigger wheel positioning
Ok. So which way does the timing trigger wheel go on the crank? It can go on 2 ways, 180F out. I seem to recall that it depends on the key way position? Can anyone elaborate?
Reply
0
Old Dec 10, 2025 | 10:29 PM
Share
  #2  
FDAUTO's Avatar
FDAUTO
よ*ろ*し*く*
Liked
Loved
Community Favorite
Top Answer: 1
iTrader: (8)
 
Joined: Sep 2022
Posts: 1,689
Likes: 700
From: Tampa
It only goes on one way. Yes the pins will allow you to install it 2 different ways but the bolt holes will allow only one of those ways to actually work.
Reply
2
Old Dec 11, 2025 | 01:00 PM
Share
  #3  
cardmarc's Avatar
cardmarc
Thread Starter
Full Member
Liked
Loved
Community Favorite
 
Joined: Nov 2001
Posts: 162
Likes: 4
From: Dallas/Denton, TX
Originally Posted by FDAUTO
It only goes on one way. Yes the pins will allow you to install it 2 different ways but the bolt holes will allow only one of those ways to actually work.
Duhhhh, sorry for the post. I must be remerbering when I rebuild a 2nd gen, not the FD I'm doing now.
Reply
0
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
bent trigger wheel
Moe Greene
3rd Generation Specific (1993-2002)
11
Nov 10, 2017 07:13 AM
Megasquirt Modded CAS, MS2- trigger wheel settings?
papiogxl
Megasquirt Forum
0
May 4, 2011 02:05 AM
Mounting bolt slop in the stock trigger wheel
CMonakar
20B Forum
3
Dec 29, 2006 09:21 AM
Back to Subforum
3rd Gen General Discussion
View Next Unread
Part number for rubber seal on oem front bumper?




Advanced Search

All times are GMT -5. The time now is 01:21 AM.