uneven brake wear
#1
Junior Member
Thread Starter
Join Date: Jun 2001
Location: Boston, MA
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
uneven brake wear
I have a 94 RX-7 and my dad was changing the brake pads.
First of all we put on Hawk pads and noticed that it fit better removing the new smaller shim glued to the pad.
However, He noticed that only the back brakes and only the inside ones are worn. In fact they were paper thin. Anyone with ideas? Is there an adjustment that needs to be made?
Thanks.
First of all we put on Hawk pads and noticed that it fit better removing the new smaller shim glued to the pad.
However, He noticed that only the back brakes and only the inside ones are worn. In fact they were paper thin. Anyone with ideas? Is there an adjustment that needs to be made?
Thanks.
#2
Full Member
Join Date: Apr 2001
Location: Sydney,NSW,Australia
Posts: 103
Likes: 0
Received 0 Likes
on
0 Posts
make sure the caliper slides are free and loose,not seized.They have to be able to move freely in and out.
If thats good,then i would recomend caliper overhaul,the piston might not be returning properly seized causing the inner pad to drag.
If thats good,then i would recomend caliper overhaul,the piston might not be returning properly seized causing the inner pad to drag.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
Tem120
3rd Generation Specific (1993-2002)
4
09-07-15 09:53 AM