2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

yet another problem

Thread Tools
 
Search this Thread
 
Old Oct 10, 2004 | 07:08 PM
  #1  
xvampyrex's Avatar
Thread Starter
Senior Member
Tenured Member 05 Years
 
Joined: Feb 2004
Posts: 264
Likes: 0
From: Vega Alta, PR
yet another problem

ok if you have read my other posts Im having issues with my engine heating up.....sorry for starting a new thread but Im having another issue....twice my car has stayed revved up at 2k for 5 min then it lowers back down to normal idle....and twice when I started my car it started up really bad, the idle was very bouncy and the revvs up were slow and very bouncy......anyone know what is wrong with my car now........-=sighs=- thanks in advance
Reply
Old Oct 10, 2004 | 07:55 PM
  #2  
PsikoticPersian's Avatar
Junior Member
Tenured Member 05 Years
 
Joined: Jan 2004
Posts: 20
Likes: 0
From: Agoura Hills
alot of the "bouncy" revs ususally come from a vacume leak. As far as the revs going up to 2k, can you make them drop by steping on the gas for a sec... or dose it just fall right back down to 2K? and is it a hard cold start? And as far as your heat issue... TAKE OUT THE THERMOSTAT...hehe... oh and dont use A/C. and check your water pump... hope this helps get from point a to point a1/4...
Reply
Old Oct 10, 2004 | 09:43 PM
  #3  
xvampyrex's Avatar
Thread Starter
Senior Member
Tenured Member 05 Years
 
Joined: Feb 2004
Posts: 264
Likes: 0
From: Vega Alta, PR
the bouncyness stops after acouple of revs up tho...so I dun think its a vaccum leak....and the 2k rev stops once I get in a high gear and slow down the car while its still in gear. Also, alot of people say not to run without the thermostat.....and Im going to check my waterpump n **** this week.
Reply
Old Oct 10, 2004 | 09:58 PM
  #4  
WAYNE88N/A's Avatar
Lives on the Forum
Tenured Member 05 Years
 
Joined: Feb 2004
Posts: 5,721
Likes: 3
From: Coldspring TX
Have you messed with your mechanical or electrical idle adjustments recently?

Does she ever settle down to around a 750 rpm idle?

Unplug the bac valve and warm her up- what is the idle now, with no electrical loads?
Reply
Old Oct 11, 2004 | 05:51 AM
  #5  
xvampyrex's Avatar
Thread Starter
Senior Member
Tenured Member 05 Years
 
Joined: Feb 2004
Posts: 264
Likes: 0
From: Vega Alta, PR
no I dont think I have messed with any idling things, hmm some water might have fallen on it but could that be the problem? She idles at around 1k...and Im sorry Im sort of a n00b but what and where is the bac valve? Oh yea anf I forgot to mention before, it revs up slowly and the whole car shakes, even mufflers.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
WyomingTII
2nd Generation Specific (1986-1992)
12
Sep 28, 2015 10:32 AM
lnlreaper
2nd Generation Specific (1986-1992)
2
Sep 27, 2015 09:59 AM
The1Sun
1st Generation Specific (1979-1985)
7
Sep 18, 2015 07:13 PM
The1Sun
New Member RX-7 Technical
5
Sep 15, 2015 04:45 PM




All times are GMT -5. The time now is 06:51 AM.