http://cgi.ebay.com/ebaymotors/ws/eB...tem=2445300608 i was wondering what it would take to fit these ****'s in my car. well not these but something like it.

 

If you know someone that could fab up some brackets It wouldnt be too difficult... maybe pricey tho. Unless whoever is selling them can supply you with them. If your not to picky you can go with 2 non - adj. seats and brackets for almost that same price is you shop around. I dont know anything about rallyart tho.. not sure if there any good.

 

well i work at a rental place with almost every tool you can think of so i dont think it will be to hard.

 

when i put my sparco in i just used the stock rails.

i would recommend taht due to the countour of the floor and the mounting points being very strong.

I used two bars and put the holes where it needed to be. I had to use a wide one b/c the offset of the holes.



|........................|
|--0----------0----| <--- new seat holes
0------------------0 <--- olde mounting points
|........................|
|........................| <----stock rail
|........................|
|---0-------0------|
0------------------0 <---metal bar
|........................|


(well my formating didn't turn out well )

(that would be an ideal case- mine were more like this)


stock rail


|........................|
0------------------0---- <---olde mounting points
|-------0----------|---0 <--- new seat holes
|........................|
|........................| <----stock rail
|........................|
0------------------0-----
|-------0-----------|---0 <----- metal bar
|........................|

the seat had to be mounted to the drivers side by about 1inch other wise it would not fit b/c would hit the center divider.