would these injector work fine
#1
Senior Member
Thread Starter
iTrader: (8)
Join Date: Mar 2007
Location: scranton Pa
Posts: 440
Likes: 0
Received 0 Likes
on
0 Posts
would these injector work fine
I haven't put them on yet, but from I understand they should fit fine. But what I'm wondering is that the injectors nipple is so much shorter then the denso one. are these going to work? By the way these are delphi 1000cc I know they are cheap but i'm just wondering if they would work.
#2
Rotary Enthusiast
iTrader: (2)
Join Date: May 2005
Location: E-L Netherlands
Posts: 1,165
Likes: 0
Received 0 Likes
on
0 Posts
no..
Besides that, Youre looking at the differences at the bottom, but you forgot to notice that the bosch style has a 14mm oring compared to the stock 11mm.
These injectorse do NOT fit in the stock fuelrails!
You would need denso type injectors or aftermarket fuelrails like KG or supernow
Besides that, Youre looking at the differences at the bottom, but you forgot to notice that the bosch style has a 14mm oring compared to the stock 11mm.
These injectorse do NOT fit in the stock fuelrails!
You would need denso type injectors or aftermarket fuelrails like KG or supernow
#3
Rotary Freak
iTrader: (7)
I have the Delphi 1000cc injectors pictured above and Furb is right you have to get them modified so they fit in the rail. The top where the oring goes has to be machined smaller and I remember having to modify the bottom just slighty to make the oring/washer fit and so they fit inside the little plastic diffusers in the manifold.
I picked up the Delphi injectors from Keith at KGparts and he had already modified them to fit the rail. This is his injector cleaning website. http://injector-rehab.com/frontdesk/ or you can get ahold of him through. http://kgparts.com/
I picked up the Delphi injectors from Keith at KGparts and he had already modified them to fit the rail. This is his injector cleaning website. http://injector-rehab.com/frontdesk/ or you can get ahold of him through. http://kgparts.com/
#4
Senior Member
Thread Starter
iTrader: (8)
Join Date: Mar 2007
Location: scranton Pa
Posts: 440
Likes: 0
Received 0 Likes
on
0 Posts
I have the Delphi 1000cc injectors pictured above and Furb is right you have to get them modified so they fit in the rail. The top where the oring goes has to be machined smaller and I remember having to modify the bottom just slighty to make the oring/washer fit and so they fit inside the little plastic diffusers in the manifold.
I picked up the Delphi injectors from Keith at KGparts and he had already modified them to fit the rail. This is his injector cleaning website. http://injector-rehab.com/frontdesk/ or you can get ahold of him through. http://kgparts.com/
I picked up the Delphi injectors from Keith at KGparts and he had already modified them to fit the rail. This is his injector cleaning website. http://injector-rehab.com/frontdesk/ or you can get ahold of him through. http://kgparts.com/
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
sherff
Adaptronic Engine Mgmt - AUS
9
02-24-19 12:09 PM