It won't start.... After Vacrac removal... Sob sob...
#1
Epitrochoid Chamber FTW
Thread Starter
It won't start.... After Vacrac removal... Sob sob...
Well... Cleaned all injectors... New fuel lines... I plugged every remaining mysterious vacuum hole left hanging open...
Cranking and no start. I did pressurize the fuel system and found no leaks.. I could hear the fuel in running in there! That was neat...
So my question is, do I try the ATF start on it? With all the cranking did it flood it?
Or is there an other series of things I should look at first?
I was very thorough in the reassembly, I really don't know what it could be...
Thanx!
sob, sob...
Cranking and no start. I did pressurize the fuel system and found no leaks.. I could hear the fuel in running in there! That was neat...
So my question is, do I try the ATF start on it? With all the cranking did it flood it?
Or is there an other series of things I should look at first?
I was very thorough in the reassembly, I really don't know what it could be...
Thanx!
sob, sob...
#3
Epitrochoid Chamber FTW
Thread Starter
When I had my FPR solenoid hooked up exactly to this drawing, with the fuel system pressurizing I had gasoline coming out of the breather on the solenoid?
Any ideas? I know that's not right.
Any ideas? I know that's not right.
Thread
Thread Starter
Forum
Replies
Last Post
Red-Dragon_Akuma
New Member RX-7 Technical
11
09-28-15 06:09 AM