Will my injectors handle the mods?
#1
Will my injectors handle the mods?
I've got a Brand new not broken in S4/5 TII engine.
It's got S4 rotors so it's lower compression.
It's got everything else S5(Manifolds/Turbo).
My question is will my 550 injectors keep ups with my mods below? I just had them cleaned and flow tested too.
2 are a 5500 1350 series and the other 2 5500 1370 which flowed an estimated 1-2% more than the 1350's.
I have Racing beat Down pipe to Presilencer(no cat) then Cork sport 2.5 to 3 inch single exhaust.
I've ported the wastegate and have a Walbro ready for the car.
I'm going to use the stock TID until I can fab up one.
Do you think my 550's will hold up pretty well? Any idea of what boost I might see?
It's got S4 rotors so it's lower compression.
It's got everything else S5(Manifolds/Turbo).
My question is will my 550 injectors keep ups with my mods below? I just had them cleaned and flow tested too.
2 are a 5500 1350 series and the other 2 5500 1370 which flowed an estimated 1-2% more than the 1350's.
I have Racing beat Down pipe to Presilencer(no cat) then Cork sport 2.5 to 3 inch single exhaust.
I've ported the wastegate and have a Walbro ready for the car.
I'm going to use the stock TID until I can fab up one.
Do you think my 550's will hold up pretty well? Any idea of what boost I might see?
#4
Rotary Enthusiast
Join Date: Sep 2002
Location: Statesboro, GA
Posts: 1,233
Likes: 0
Received 0 Likes
on
0 Posts
ya dude, all the injectors should be the same. with stock intake and ported wastegate, you should be fine with stock injectors.
basically you have a stock motor with exhaust and ported wastegate. without turning the boost back up, you probably aren't seeing anywhere near the limit of the injectors.
basically you have a stock motor with exhaust and ported wastegate. without turning the boost back up, you probably aren't seeing anywhere near the limit of the injectors.