Car will finally be running next week when i buy a k2rd rail and new haltech wiring harness.... Can't wait!!
Last time it ran it had, what 146hp?

 

very clean engine bay, although I can't help but notice your air filter will be sucking in all that hot air after the radiator. Wow only 146 hp? what was that an N/A.

Just remember lower intake temps lower temps after the turbo and less cooling our TMIC will have to do...but once you get a front mount it should help greatly.... you need to list your mods, how much did that FPR setup cost, looks really nice

What kinda gauge is that under your boost gauge?

 

I am just rushing it to burn out at my highschool graduation thats all, I will be doing a TID to throw the cone right behind the passenger headlight along with a fmic and gp sports front bumper this summer... And slicks/ yadada list goes on... Yes it was an n/a a GTU. Thxs for the compliments...

 

hehe I wish I coulda had my car done on my graduation, the best and the easiest time to get Laid!!!!

 

lookin' good man! nice and clean...

is the intercooler tilted or the motor leaning? or are my eyes deceiving me in the last 2 pics?

 

yea the ic is leaning i really didn't have it on there

 

what's a tid?

 

Turbo Inlet Duct, just some piping inbetween the air filter and the turbo..

 

Very nice Revvin, you've always had one of the cleanest damn FC's I've ever seen. I can't wait to get your old NA engine running

 

I hope to have my car done by graduation also, Kevin is supposedly building my engine right now.

 

That looks amazing! One question though, is it me or does the intercooler look like its at a funny angle? The passanger side is higher than the driver side.

 

Yea I have to figure that bs out, and i don't have the driver side mounting bracket for the ic. I think the stock hoses have shrunk compicating it more.... Thxs for all the compliments

 

Damn. Your car looks very good. Hopefully you can show us some pics at your graduation when u burn out.

 

I don't think i will be able to having tranny/clutch problems........

 

Sick car, nice job, i wish i had all those mods when i graduated high school.
Just out of curiosty, how did u get rid of your mass air sensor.

 

If possible... I wanted to see the BOV set-up. Like the hoses and the vacume line(s).

Thanks.

 

I could try and get some more pixs tommorrow, i got rid of the MAF sensor because I have a haltech

 

nice setup. I wish i had that kinda money when i was in hs. Im planin' on doing a similar swap, i might use my N/A motor though, who knows. Anyways, what driveline are you using? the stock N/A one? Keep us updated

 

Yeeah! You will have the best ride at graduation.

 

I have a t2 drivetrain in. Well i found out i need a tranny rebuild so i can't burn out...