who has had troble w/this harness
#1
Junior Member
Thread Starter
Join Date: Mar 2002
Location: SLIDELL,LOUISIANA
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
who has had troble w/this harness
who here has had troble w/the harness under tps that has the o2 wire coming out of it. i have a 10th ae and my harness plug is falling apart was causing my car to loop and run sort of rich. anybody..... thanks
p.s. how did you solve it
p.s. how did you solve it
#2
Eats, Sleeps, Dreams Rotary
iTrader: (1)
I'm not sure if you're talking about the O2 wire or not. If it is the O2 wire, just peel back covering and shielded cable to where core is not frail. I slipped heat shrink over the wire then soldered it. Put heat shrink over it. If this is the wire your speaking of, make sure no part of the shielded portion is in the solder, or it will ground not giving any signal to ecu. I had 2 other wires in that harness that needed to have the same treatment.
Thread
Thread Starter
Forum
Replies
Last Post
scissorhands
New Member RX-7 Technical
0
09-16-15 01:25 PM