Where Do I Run Nitrous Lines?
#1
Full Member
Thread Starter
Join Date: Feb 2007
Location: Hiawatha, IA
Posts: 171
Likes: 0
Received 0 Likes
on
0 Posts
Where Do I Run Nitrous Lines?
OK, I installed a 10lb nitrous bottle behind the passenger seat, inside the storage area. Now where th eline is going to connect to the bottle is right on top of the tunnel and i dont want to cut a hole in the floor and run the line by the exhaust (DUH!!) so i was wondering if it is OK to just run the line under the carpet, up to the front, under the dash and through the firewall? Or should i just run it to the side of the storage area and then drill a hole and run it under the car?
FTR: its on a SBF swap, not a rotary (not engine related so i dont thin this has to be in the engine swap section as it has to do with the RX7 not the engine)
shifter question is swap related so i will post there as well. With the grannys kit i got a little 3" rectangle piece with four holes in it... I assume this is the shifter piece to run the T-5 shifter out the stock hole? If so how the hell does that thing work?
FTR: its on a SBF swap, not a rotary (not engine related so i dont thin this has to be in the engine swap section as it has to do with the RX7 not the engine)
shifter question is swap related so i will post there as well. With the grannys kit i got a little 3" rectangle piece with four holes in it... I assume this is the shifter piece to run the T-5 shifter out the stock hole? If so how the hell does that thing work?
#7
Full Member
Thread Starter
Join Date: Feb 2007
Location: Hiawatha, IA
Posts: 171
Likes: 0
Received 0 Likes
on
0 Posts
Do you mean rectangle or did he not send me a shifter adapter? The piece i have is arectangle. May be 3.5" by 2" or so... with two holes on each end...
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
Frisky Arab
2nd Generation Specific (1986-1992)
13
08-18-15 05:30 PM