Where can i get piping kit for a fmic?
09-19-05, 10:28 AM
#1
Full Member
Thread Starter
Join Date: Nov 2004
Location: new york
Posts: 61
Likes: 0
Received 0 Likes
on
0 Posts
Where can i get piping kit for a fmic?
I have a 88 tii that i want to put a front mount on. Do any websites sell the piping already done or the whole kit with the intercooler?
09-19-05, 10:44 AM
#2
Locust of the apocalypse
Join Date: Apr 2003
Location: Directly above the center of the earth (York, PA)
Posts: 2,553
Likes: 0
Received 1 Like
on
1 Post
Of course man....
RX7store.net
Rotary Extreme
RX7.com
The Greedy's will run you about 950 bucks for the 2-row and about 1350 for the 3 row.
Problem is with the S4, the plumbings a little hairy around the PS pump (if you got one) and the batter needs to go in the back bin.
So, figure another 100 on battery relocation parts.
If thats too much, you have to DIY.. costs around 5-700 depending on what you get.. thats if you can weld steel.... If you want aluminum pipes, the price just went a little nutsy, especially if you are not a TIG welder and have to pay somebody for that.
I'll be selling my custom FMIC in a couple of days in the parts section, I'm going to have the Tubes Powedercoated with chromecat before i sell it, as they are steel, (I don't have access to a TIG welder anymore)
RX7store.net
Rotary Extreme
RX7.com
The Greedy's will run you about 950 bucks for the 2-row and about 1350 for the 3 row.
Problem is with the S4, the plumbings a little hairy around the PS pump (if you got one) and the batter needs to go in the back bin.
So, figure another 100 on battery relocation parts.
If thats too much, you have to DIY.. costs around 5-700 depending on what you get.. thats if you can weld steel.... If you want aluminum pipes, the price just went a little nutsy, especially if you are not a TIG welder and have to pay somebody for that.
I'll be selling my custom FMIC in a couple of days in the parts section, I'm going to have the Tubes Powedercoated with chromecat before i sell it, as they are steel, (I don't have access to a TIG welder anymore)
09-19-05, 05:01 PM
#5
Senior Member
Join Date: May 2003
Location: In a house
Posts: 520
Likes: 0
Received 0 Likes
on
0 Posts
A DIY kit is more than the Greddy kit if you use all the right parts. Piping is easy if you enjoy doing stuff yourself. 3 u-bends and 4 feet of straight pipe and I was done. GL.
Thread
Thread Starter
Forum
Replies
Last Post