what size is that big old bolt on the flywheel,and how can i take it off with making the motor spin. ?????

 

54mm or 2-1/8".

Buy or make an item like this:



Oh, and next time, do a search!

 

Use an Impact gun, you do not need a flywheel stop if you use one of those.

 

yeah... good luck... hope your transmission install goes smoothly.... unlike MINE now....

 

thanks guys, luv this forum

 

the 2 1/8" is your best bet...they are like half the price of a 54mm. sears has them in stock usually, but 54mm is special order.

 

how much do they go for cuz iam about to go buy 1 rite now.

 

2 1/8 inch socket for a 1 inch drive rachet is $22.99... Sears does not carry a 54mm socket.

 

good looking iam go buy it rite now

 

i think it was a 3/4 drive right?

 

Yeah... 3/4 drive rachet.

 

dun need a flywheel stop if ya use a engine stand and a peice of rebar.. an 8 foot long pipe and a little pissed off **** you up you stupid peice of **** of a flywheel bolt.. and it'll come right off..

 

if u look at the flywheel theres some holes around the middle by the bolt, iam guessing thats how u should take off the bolt by screing bolts in there that stops the flywheel, thats how it was on my goped, lol, i just put a flathead and it stoped it and did the good,

 

yea impact gun is definitly the way to go. It takes no effort at all. Just make sure to get the 3/4 to 1/2 adapter to fit the impact gun.