What needed to install warlbro
#1
Senior Member
Thread Starter
Join Date: Nov 2004
Location: co
Posts: 484
Likes: 0
Received 0 Likes
on
0 Posts
What needed to install warlbro
hi i found a walbro 255 for 50 bucks but its a universal app. What all is needed t install it in a 87 t2?? Do I just need the pump or is there something special for the wiring like a harness or adapter?? Is it worth it to buy one from a rotary specific shope like corksport or something?? Thanks
#2
You don't need to buy one from a rotary specific shop. There are a gazillion threads. Search for walbro re-wire. You'll need a part from radio shack for like 3 bucks, and the ehat sink from the front of the engine bay. You'll need a length of wires. Bah, it's been a while since I did mine. I forgot.
EDIT:
http://www.1300cc.com/howto/how2/rewire.htm There ya go.
EDIT:
http://www.1300cc.com/howto/how2/rewire.htm There ya go.
#3
Seduced by the DARK SIDE
Join Date: Apr 2001
Location: Orange Park FL (near Jax)
Posts: 7,323
Likes: 0
Received 2 Likes
on
2 Posts
There are two issues here.
Splicing in the pump wires only requires getting the +/- polarity right, solder & heat shrink.
Getting full voltage and current to run the pump (mentioned above) is the other issue.
Splicing in the pump wires only requires getting the +/- polarity right, solder & heat shrink.
Getting full voltage and current to run the pump (mentioned above) is the other issue.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM