what all parts am i going to need to install power windows and locks i want to convert the power window swiches to the center consol by the change holder
also is remote start possable on a 1.3B 5 spd

 

I dont think so but you can look into it most companies only make it for automatic trannies but you can call around or look it up

 

Yes, remote start is possible.

 

Too bad you didn't live closer... I'd swap ya for my power window setup. I want roller-uppers.

 

I have a remote start. There's a special part they meed to add to trip the clutch when you remote start it, and you can't remote start it unless you use the remote starter to turn it off. This is so that there is no chance of you remote starting it in grear or with out the hand break on.

 

As for the power windows I just did that...you will need 2 power window motors, the switches for each side, if you are putting them in the center console U will need I think a 5 prong for the drivers side and three prong for the right, your old windows you keep, the window guides you can keep, you will need new door interior, and lots of wires and an factory service manual on the wires...other than that have fun making a new wire harness, this isnt really plug and play....as for power locks...I havent got that far yet...and if anyone needs a roller upper.....pm me I have my old ones left