What are the best mods for second gen. N\A's that give the biggest hop in hp/tourque?
#51
Eat Rice Don't Drive it.
iTrader: (3)
Originally posted by dr0x
I feel that way too. Which is why when I get mine Im bridging the spare exhaust cut out in the bumper so it doesnt look so lonely
I feel that way too. Which is why when I get mine Im bridging the spare exhaust cut out in the bumper so it doesnt look so lonely
#52
Eat Rice Don't Drive it.
iTrader: (3)
Well I think we have bored this guy enough with the exhaust stuff. since he already has a cat-back just get the RB collected header and pre-silencer.
Well you can get some of these too:
Pineapple racing sleeves
polish/port your intake
loose weight
make some cold air ducts to feed your intake
get carbon fiber stuff like a hood
i saw way back some fenders made out of cf on ebay
Well you can get some of these too:
Pineapple racing sleeves
polish/port your intake
loose weight
make some cold air ducts to feed your intake
get carbon fiber stuff like a hood
i saw way back some fenders made out of cf on ebay
#55
13B N/A POWA!
Join Date: Apr 2002
Location: Everywhere, WRLD
Posts: 1,013
Likes: 0
Received 0 Likes
on
0 Posts
I also agree on the single exit exhaust looks. The dual exit is like a trademark/birthmark of the 7 series (aka it's the only car with one...the others just have dual outlets on one muffler). As far as bang for you buck, I'd pick up the duals from mazdatrix and an nice filter (I use bonez) and make some piping for the intake. Take the plates out of the throttle body (of course not the back/primary plates ) which gives a very nice increase in responsiveness, get rid of the A/C (keep powersteering...no sports car should have a ratio higher than 2.8:1 ), make sure the auxilary ports work or get rid of them all together if you don't mind losing the low end (I mind very much), and port match the manifolds to the gaskets. There are more things you can do, but at least those things you can do w/very little fuss, and w/out taking the motor apart just yet. Good luck
#60
Lets not get off base here. Carbon Fiber parts are by no way cheap and they do little for performance, so those are out. PA racing sleeves are cheap and are a good improvement to your 13B. If you have a base model, like me, getting an LSD off of an S4 GXL is a good idea. Ya can also port the throttle body elbow, but this probably wont do anything unless you have a ported motor.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
risingsunroof82
1st Generation Specific (1979-1985)
8
09-07-15 01:11 PM
ray green
1st Gen General Discussion
2
09-02-15 06:35 AM