Were to put jack stands???? (searched)
#1
Rotary Enthusiast
Thread Starter
Were to put jack stands???? (searched)
Were are the proper jack points for my 1991 FC???? Ive spent a hour looking at the FSM, but i cant seem to find anything. I know to jack up the rear of the car by the diff...
but were are the front and rear jack stand points?
and were is the front jack points?
Pictures would be greatly apreciated..
I hate guessing on this type of stuff
but were are the front and rear jack stand points?
and were is the front jack points?
Pictures would be greatly apreciated..
I hate guessing on this type of stuff
#4
Full Member
Join Date: Sep 2006
Location: Coquitlam BC
Posts: 238
Likes: 0
Received 0 Likes
on
0 Posts
also its ok to put stands on the X member, cuz its ussually stronger than the front floor supports. (blue circles in the pic above). Cuz when i lowered the front on the front floor supports it bent a bit, but when i lower it on the x member it doesnt bend.
Stands for the rear
Dont lower them on the rear section of the floor supports (red circle) As you can see when i did it, it got bent bad.
Put stands on the rear subframe (green circle)
http://tinypic.com/view.php?pic=47sqxxv
Stands for the rear
Dont lower them on the rear section of the floor supports (red circle) As you can see when i did it, it got bent bad.
Put stands on the rear subframe (green circle)
http://tinypic.com/view.php?pic=47sqxxv
#5
Winter sucks
Join Date: Jan 2004
Location: Newberg, Oregon
Posts: 3,083
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
diabolical1
2nd Generation Specific (1986-1992)
30
01-30-16 05:50 AM