Water temperature sender size?
Thread Starter
Rotary Enthusiast
Joined: Dec 2001
Posts: 1,053
Likes: 0
From: Norwich, CT
Water temperature sender size?
Hey guys, I just bought a water temperature gauge. I am looking to install it this Friday, but apparently I need an adapter to fit the sender in. So my question is, what size is the stock water temperature sender hole? The sender I have is 1/8 in size if I remember right.
SOLD THE RX-7!
Joined: Mar 2001
Posts: 7,451
Likes: 0
From: Vancouver, BC, Canada
I'm not sure but you are better off to leave the stock one too.... try putting it somewhere else if you can. the best place is by the thermostat but you'd probably have to take the water pump off to do it right...
Rotary Enthusiast
Joined: Jan 2002
Posts: 958
Likes: 0
From: Rochester, NY
The stock sender thread is an 1/8"BSP?
anyone?
I rather not drill into the water pump housing, so I'm looking to put an aftermarket guage where the stock sensor is.
Is this the best spot for accuracy?
anyone?
I rather not drill into the water pump housing, so I'm looking to put an aftermarket guage where the stock sensor is.
Is this the best spot for accuracy?
Senior Member
Joined: Apr 2002
Posts: 259
Likes: 0
From: Jersey
i had this problem, i just went out and bought the greddy adapter...basically u cut a piece of yer radiator hose, put this metal "hose" in the little section you cut...it has the sensor housing built into it...
Thread
Thread Starter
Forum
Replies
Last Post
[For Sale] Scratch & Dent, Used, and Open-Box Sale!
SakeBomb Garage
Vendor Classifieds
5
Aug 9, 2018 05:54 PM
rx8volks
Canadian Forum
0
Sep 1, 2015 11:02 PM