water temp sensors relocation good ida or bad ida need anwser
#1
water temp sensors relocation good ida or bad ida need anwser
Hi
Ok so i have an 87 t2 w/ lots of mods and now ive drilled and taped the back of the water pump housing a few times for water temp gauges and e-fan gauges etc.
well now that i have all those gauges back there is it ok to relocate the water temp sensor to the water pump fillter neck??? i would have to extend the eonnector but thats not big deal. what im worried about is the gauge not reading right
well i want to know what u guys think.
Ok so i have an 87 t2 w/ lots of mods and now ive drilled and taped the back of the water pump housing a few times for water temp gauges and e-fan gauges etc.
well now that i have all those gauges back there is it ok to relocate the water temp sensor to the water pump fillter neck??? i would have to extend the eonnector but thats not big deal. what im worried about is the gauge not reading right
well i want to know what u guys think.
Last edited by chrisw80; 08-04-07 at 10:49 PM. Reason: spelling
#2
I'm a boost creep...
Join Date: Jan 2002
Location: Auckland, New Zealand
Posts: 15,608
Likes: 0
Received 8 Likes
on
8 Posts
It should be mounted under the thermostat or it'll be sending the ECU an incorrect signal during warm-up. It shouldn't have been moved from its stock position. You should've found other locations for aftermarket sensor(s) instead, like this:
https://www.rx7club.com/showthread.p...42#post5346642
https://www.rx7club.com/showthread.p...42#post5346642
Thread
Thread Starter
Forum
Replies
Last Post
sherff
Adaptronic Engine Mgmt - AUS
9
02-24-19 12:09 PM
immanuel__7
2nd Generation Specific (1986-1992)
89
09-05-15 10:23 AM
befarrer
Microtech
3
08-22-15 05:52 PM