water temp and fuel gauge problem
#1
Senior Member
Thread Starter
Join Date: Jul 2001
Location: Parma, MI
Posts: 412
Likes: 0
Received 0 Likes
on
0 Posts
water temp and fuel gauge problem
Ever get where the fuel gauge will go past the full mark and the water temp will rise up to hot? It used to do this once and a while but has been doing it more often lately. Any clue how to fix?
#2
Just Looking Around
Join Date: Jan 2002
Location: Fort Benning, Ga./ Anna, Tx.
Posts: 1,830
Likes: 0
Received 0 Likes
on
0 Posts
I don't know, but I'm having similar problems. My temp gauge just dies when I go into boost. Stays dead for awhile then pops back up to its normal temp. Is this a problem on FC's?
#3
Super Raterhater
iTrader: (6)
Join Date: Dec 2001
Location: NY, MA, MI, OR, TX, and now LA or AZ!
Posts: 10,627
Likes: 0
Received 2 Likes
on
2 Posts
Usually caused by cold solder joints, read the FC FAQ sticky'ed at the top of the main page, or search on the username 'Icemark' and you'll find a lot of info.
#5
Senior Member
Thread Starter
Join Date: Jul 2001
Location: Parma, MI
Posts: 412
Likes: 0
Received 0 Likes
on
0 Posts
cold solder joints in the cpu? I resoldered that before to try and fix horns. Or is it the ecu? Resoldered some spots while I was doing the BAC transistor fix, maybe I didn't get one so well. It doesn't do it all the time.
Thread
Thread Starter
Forum
Replies
Last Post
sherff
Adaptronic Engine Mgmt - AUS
9
02-24-19 12:09 PM
immanuel__7
2nd Generation Specific (1986-1992)
89
09-05-15 10:23 AM
befarrer
Microtech
3
08-22-15 05:52 PM