Hey guys -

I'm sitting on a second hand Walbro fuel pump that I didn't get installation instructions for. I've done a forum search and a google search and came up nil.

Can someone post the install procedure? At this point, I'm not even real sure where it goes - I'm guessing under that plate on the driver's side of the back area.

Thanks, and it's a Turbo II

 

Undo the 10 screws on the fuel pump cover, pull out the fuel pump assembly, unbolt the 2 screws holding the wires for the stock pump on, unclamp the fuel hose, pull off pump, put insulator boot on the walbro and put it on the mount, clamp down fuel line, bolt down the + and - wires, put filter screen on, put pump back into the tank, remove the output hose on the top of the tank assembly and jumper the yellow connector in the engine bay and turn the key to ON and watch for fuel. If there is turn it off and screw the assembly back down and clamp the output hose down. Remove yellow connector jumper. Done.

 

man its so straight forward, i never even used the directions

 

Damn it, I just knew some show-off would come in here and flame me for that. If you're not going to help, why do you even bother posting? We're all supposed to be here to help each other - not push up post count.

Hey - thanks, Dr0x. I'll get right on it.

 

seriously though, if you know where the fuel pump is its really easy, hey i'll send you my directions that i didn't use you you want...

 

For the benefit of future searches, I found this:

http://pbgarrott.tripod.com/Fuel/index.html

 

this says stuff about the fuel rail and the fuel pressure regulator.... do i have to change/mod my FPR with the walbro?