Underside picture ?
#1
Full Member
Thread Starter
Join Date: Jan 2003
Location: Ottawa
Posts: 81
Likes: 0
Received 0 Likes
on
0 Posts
Underside picture ?
Does someone have a good underside picture of a RX without the exhaust system ? I'm asking this cause I'm 250 km away from the shop where I work on my car (Hey it's free and it's a welding shop) so I would like to have a good idea of how to do mine before getting down there cause I can only work on the week ends.
Thanks !
Thanks !
#2
I wanta be with the BUC!
Join Date: Jan 2003
Location: Knoxville, TN
Posts: 2,305
Likes: 0
Received 0 Likes
on
0 Posts
Are you going to put the muffler in the back???
If so you really don't need to see any picture, because it is straight forward if you use the stock muffler holes.
But if you want to put it somewere else (like under the car), then it will take a little more planning, and building.
If so you really don't need to see any picture, because it is straight forward if you use the stock muffler holes.
But if you want to put it somewere else (like under the car), then it will take a little more planning, and building.
#3
Full Member
Thread Starter
Join Date: Jan 2003
Location: Ottawa
Posts: 81
Likes: 0
Received 0 Likes
on
0 Posts
As I do not have a lot of time, I was thinking of going 3" single strait to the back with the muffler in the original place. I just want to try planning what tubing to buy. (lengthwise and bends)
Edit : I'm just finishing a TII conversion, that explain the 3" single choice
Edit : I'm just finishing a TII conversion, that explain the 3" single choice
Thread
Thread Starter
Forum
Replies
Last Post
ray green
1st Gen General Discussion
2
09-02-15 06:35 AM