where do they sell them? and how much? tired of hearing the clunk sound when shifting~!

 

I was going to have one machined from aluminum. Just a solid block of alum, tapped for studs, and will be a direct bolt-in replacement for the stock rubber one. Should I check into a group buy?

 

you could also just have a big piece of metal welded in there like I did! Soul assasin is running that scheme too, and he's pushin like 500hp...

 

Don't laugh but a friend of mine did one out of a block of wood and it's still holding. 3 yrs later........ it runs 13's ....I think that would be the cheapest option. The USS Constitution is made out of wood and it's over 200 years old.

 

I had my welded also. works good so far.

 

How much did it cost to weld that into place?

 

Well, its looking like I wont need them any time soon. I simply do not get wheel hop. I can drop my clutch at 5K, bounce off the rev limiter in 1st until I catch traction, and still dont get hop.