Turbo II Need advice starting engine
#1
Turbo II Need advice starting engine
I just did a NA to TII swap all the wiring is done right and checked again every thing is connected. The motor turns over but dosnt start, one of the things I am worried about is how the fuel system is supposed to be setup on the motor.
On the driverside where under the IC there are three hard fuel lines and I have only 2 fuel lines 1 pressure and 1 return. The NA motor only has 2 I checked my other Rx7 to confirm this, My question is what do I hook up the fuel going in to and where do I hook up the return line I will Post up the pics later today.
Also this is a JDM engine I read on one post Im supposed to reverse the pressure and return fuel lines but Im still not sure what is supposed to go where.
Thanks
Tony
On the driverside where under the IC there are three hard fuel lines and I have only 2 fuel lines 1 pressure and 1 return. The NA motor only has 2 I checked my other Rx7 to confirm this, My question is what do I hook up the fuel going in to and where do I hook up the return line I will Post up the pics later today.
Also this is a JDM engine I read on one post Im supposed to reverse the pressure and return fuel lines but Im still not sure what is supposed to go where.
Thanks
Tony
Last edited by Fattony; 08-16-07 at 12:40 PM. Reason: adding info
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
KAL797
Test Area 51
0
08-11-15 03:47 PM