2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

transmission problem

Thread Tools
 
Search this Thread
 
Old Oct 10, 2006 | 05:49 PM
  #1  
namelesspenguin's Avatar
Thread Starter
chasing those red numbers
Tenured Member 15 Years
iTrader: (1)
 
Joined: Apr 2006
Posts: 447
Likes: 0
From: Colton, Ca
transmission problem

ok. so i was driving home today and as i go to shift into fourth, i hear a loud crack-ish noise. i am no longer able to shift into any gears so i pull over n turn off the car. i look under the hood and car and nothing is visibly wrong. so i turn the car back on and after about 20 seconds i can put it in gear again. but as i hold down the clutch t shift, theres a loud squeeking noise. IN EVERY GEAR!!! and i can feel a vibration in the clutch pedal that was never there before. also, when i hold the clutch in while its in nuetral, the car dies.

so im pretty sure its either the clutch or the pressure plate.
maybe even both.
anyone ever run into sumthing like this?
any suggestions on what else it mite be or what i can do?
thanks for the help

(na s4)
Reply
Old Oct 10, 2006 | 05:56 PM
  #2  
aznpoopy's Avatar
strike up the paean
Tenured Member 20 Years
 
Joined: Aug 2003
Posts: 2,495
Likes: 2
From: fort lee, nj
sounds like an issue with the pressure plate teeth and/or throw out bearing
maybe you snapped some teeth off the plate

only one way to check! XD
pull that bitch off
Reply
Old Oct 10, 2006 | 06:38 PM
  #3  
namelesspenguin's Avatar
Thread Starter
chasing those red numbers
Tenured Member 15 Years
iTrader: (1)
 
Joined: Apr 2006
Posts: 447
Likes: 0
From: Colton, Ca
*sigh*
Reply
Old Oct 10, 2006 | 07:12 PM
  #4  
hondaslaya's Avatar
SA hole
Tenured Member 10 Years
iTrader: (3)
 
Joined: Aug 2004
Posts: 307
Likes: 0
From: Planet Piss
you blew your clutch or one of the gears in the trans went out. you need to replace both. while your at it replace your slave cylinder also
Reply
Old Oct 10, 2006 | 07:35 PM
  #5  
namelesspenguin's Avatar
Thread Starter
chasing those red numbers
Tenured Member 15 Years
iTrader: (1)
 
Joined: Apr 2006
Posts: 447
Likes: 0
From: Colton, Ca
i was thinking of replacing both master and slave cylinders anyway.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Enzo1944
New Member RX-7 Technical
2
Sep 6, 2015 08:57 AM




All times are GMT -5. The time now is 11:36 AM.