RE TurboII

iTrader: (2)

I just finished my s5 TII swap into my s4 TII and i knew the tranny mount wouldn't line up cuz of the difference in the rubber mounts. i was just curious if any s5 mount would work. im speaking about the Cross Member looking part of the mount. i have the rubber pieces but i just need to make sure that the s5 tranny cross member part will bolt up to the chassis. need an answer asap because this is keeping me from driving my car.

BlueTII

No, you need to have an S5 TII cross member as well as the mounting bracket that bolts to the trans (which is different from the S4). This of course only matters if you installed an S5 TII trans.

RE TurboII

iTrader: (2)

i have the mounting bracket with the two rubber peices that were visibly way differen't then the s4 TII one so all i need is the cross member part. right now my tranny is being held up by a rope that is wrapped underneath the tranny and looping out of my doors around the roof 3 times. its my temporary solution but i dont drive it like that. anyone have a tranny cross member

BlueTII

I have one avaialble, you can email me at csanders@banzairacing.net