TII and turbo questions.
#1
Rotaries for life'
Thread Starter
TII and turbo questions.
Three questions. 1. Where is the screw to adjust the throttle bodies on the s4 TII throttle body? Because I've got a power fc installed and the idle won't stop surging. It's getting too much air at idle and I cant screw in the bac valve anymore. 2. What are the measurements for big shafts and normal shafts in turbo's. 3. With good tuning and a streetport how much power should I be able to make with a 60mm/80mm turbo on the compressor side matched with the stock hotside and a p trim wheel in it? Also how should spool be? Another question, is there anywhere where I can buy a flange for an s5 turbo? Any questions you can answer would be appriciated. Thanks guys and may the rotor gods forever shine on you.
#6
Rotaries for life'
Thread Starter
any body else? How much power should could I make with a 60mm/80mm turbo? And how fast should spool be with a 1.0ar divided housing and a p trim wheel?
Thread
Thread Starter
Forum
Replies
Last Post
ricardo.benin
3rd Generation Specific (1993-2002)
9
12-07-15 08:49 PM
stevexk
3rd Generation Specific (1993-2002)
19
12-03-15 10:46 AM