SAFC II killing motor

--------------------------------------------------------------------------------

i use my TII[some mods] as a weekend warrior, anyway the problem is
I start car, run for 10 minutes and it cuts out completely a couple of times,
then dies. sometimes it restarts after pulling egi fuse, also, it seems unbelievably hot around fuse box[fuse itself hot] and under hood for that amount of time. Temp. gauge ok reading. I had a SAFC expert set my car, and he said there could be a loose wire to computer. Is this where SAFC is soldered or wired to ecu? anyone have this problem?
__________________
robrxray

 

Claiming to be an expert on the S-AFC is like claiming to be an expert on toothpicks.

Anyway, back to helping you with your problem

I would definitely check your connections at the ECU where everything is soldered to gether, also check to see that you didnt pull or loosten a pin on the ECU connectors (just pull the connectors and juiggle the pin) Worst case, you can superglue the connectors back in tightly.

It sounds to me like your AFM wire is intermittant.

EDIT:

When I said superglue the connectors, I ment just the little metal pin inside the connector, not supergluing the connector to the ECU!~ :-p

 

thanx Tofuball, I hope it's that easy. Is AFM wire at ecu or other location?

 

Did you figure out the problem yet? :P