TII BAC valve same as N/A?
Thread Starter
24 yrs driving 2nd Gen RX
Joined: May 2002
Posts: 528
Likes: 0
From: A Mile Closer to God (Denver)
TII BAC valve same as N/A?
Hey Hey,
I'm troubleshooting Idle problems on my S4 TII, and have found that the resistance measurement on the BAC doesn't fit the manual spec.
So, I have a BAC from a N/A which measures spot on.
Q: can I use this one on my TII?
THX!!!!
- k -
I'm troubleshooting Idle problems on my S4 TII, and have found that the resistance measurement on the BAC doesn't fit the manual spec.
So, I have a BAC from a N/A which measures spot on.
Q: can I use this one on my TII?
THX!!!!
- k -
Lives on the Forum
Joined: Feb 2004
Posts: 5,721
Likes: 3
From: Coldspring TX
If you have the manual, then you should be able to check specs on both. If the internal plumbing is the same, and the external dimensions/gasket areas the same, I don't see why not. But isn't the turbo's idle adjust screw on the BAC itself, versus the n/a's being on the throttle body?
Thread
Thread Starter
Forum
Replies
Last Post
mulcryant
2nd Generation Specific (1986-1992)
10
Sep 9, 2015 05:24 PM
Nosferatu
2nd Generation Specific (1986-1992)
7
Sep 5, 2015 02:13 PM