Are these Rear toe bushings?
You mean DTSS Eliminators? Nope. Those are polyurethane and have grooves for holding grease. Most likely rear trailing arm bushings as they look a bit long for the front.
Thread Starter
Blue Bomber
Joined: Oct 2005
Posts: 154
Likes: 0
From: Vancouver
hmm any pics to compare size to the rear toe upright bushing so I don't end up picking up something wrong again? 
This is the bushing I need.
The ones I took pics of above are 7cm long.
This is the bushing I need.
The ones I took pics of above are 7cm long.
Joined: Sep 2005
Posts: 25,581
Likes: 136
From: Smiths Falls.(near Ottawa!.Mapquest IT!)
If you are replacing THAT bushing,then Have FUN(not to scare you).
IF you are putting IN DTSS bushings you have to take the ":race" of that bushing off the Assembly,and it is a beotch,
I used a ball joint press and assorted Sockets to press it out.I will never do that again,BUT I got it out!
If you have a Shop press Good stuff.
IF you are putting IN DTSS bushings you have to take the ":race" of that bushing off the Assembly,and it is a beotch,
I used a ball joint press and assorted Sockets to press it out.I will never do that again,BUT I got it out!
If you have a Shop press Good stuff.
Thread
Thread Starter
Forum
Replies
Last Post
GrossPolluter
Suspension/Wheels/Tires/Brakes
12
Aug 15, 2015 10:32 PM