Testing tps with VOM off car.HOW?
Thread Starter
Joined: Sep 2005
Posts: 25,581
Likes: 136
From: Smiths Falls.(near Ottawa!.Mapquest IT!)
Testing tps with VOM off car.HOW?
I have a couple TPS's here and would like to test them,make sure they are good.Also what Series they are.( I have a couple that look different..assuming s4 and s5 or something).
Which wires to I probe,and what setting on the VOM do I use?
I would rather Not test Each one on my car.The Tps's are OUt of the car and on the Bench.Thanks.STYX.
Which wires to I probe,and what setting on the VOM do I use?
I would rather Not test Each one on my car.The Tps's are OUt of the car and on the Bench.Thanks.STYX.
Joined: Dec 2006
Posts: 2,859
Likes: 13
From: Sterling Heights, MI
For the S4 ones (3-prong plug) Obtain a multimeter, stick the negative probe in the back of the plug where the black/red wire enters, and the positive in the green/red one. Push the plunger in and see if it reads less than 1k ohms, then let the plunger out and make sure the reading doesn't exceed 5-6k ohms. Also make sure the sweep from open to closed is smooth, with no jumps or dead spots.
^Hold On
Joined: Mar 2007
Posts: 1,331
Likes: 1
From: eureka
Thread
Thread Starter
Forum
Replies
Last Post
The1Sun
1st Generation Specific (1979-1985)
7
Sep 18, 2015 07:13 PM
ZaqAtaq
New Member RX-7 Technical
2
Sep 5, 2015 08:57 PM
