Hi Guys. Does anyone know where I can purchase the driveshaft flange that's between the u joints and the rear end for a t2? Its the flange where you put the 4 bolts and nut that attaches to the rear end. Not the rear end part but the driveshaft part.I just installed a t2 rear end in my 87 rx7 and I need the driveshaft flange. Im greatfutl for any help. Thaks! Ariel

 

Doubt you will be able to find just the flange, and if you can, it would be at the Mazda dealership. Just look for a driveshaft in the classifieds section of the forum, there are always some floating around. Either that or post a wanted ad for the entire driveshaft.

 

the driveshafts are one piece from the dealer, the only way you will find one is farbricate it or cut up a new/used stock driveshaft.

 

mazdatrix has any driveshaft that will meet your needs

 

www.driveshaftspecialists.com out of Texas, had a larger U-joint exact replacement for $249. Delivered. The stocker was outrageous. This one has replaceable Dodge jpints. and they're greaseable.

GD

 

Thanks everyone for helping. Great info. Mazdatrix have the flange I was looking for. I also found out while looking in the junkyard today that the 8.8 flange from mid 90's lincoln towncar works. You just gave to make the bolt holes just a tad bigger and it works with my application. (Ls1 with 6 speed trans and a narrowed camaro driveshaft) The best part is that it only cost $9.00 .Once again! thanks everyone. Ariel