swapping Aftermarket 3rd gen diff into 2nd gen
02-24-13, 08:45 PM
#1
swapping Aftermarket 3rd gen diff into 2nd gen
Hey guys Ive got a 3 rotor powered FD and Im thinking about putting an 8.8 irs rear end in, in place of my Kaaz 2 way. My question is what is involved, if it is possible at all, to swap the Kaaz unit into my 2nd Gen. Its N/A. Im willing to get anything I need to make it work. Its an expensive unit and I dont want it to go to waste.. lMK guys.. thanks!
02-24-13, 11:09 PM
#2
Edited, misread your question....
in order to use your KAAZ in your FC you'll need a TurboII rearend, the FD LSD will drop right into that. (up until recently I was using an FD torsen in my TII)
you'll also need a special driveshaft to use a TII rear end with an NA trans (mazdatrix sells them), or just get a TII trans...
Also, you'll need S4 stub shafts for the rear end... S5 TII viscous stub shafts won't work on any aftermarket LSDs.
in order to use your KAAZ in your FC you'll need a TurboII rearend, the FD LSD will drop right into that. (up until recently I was using an FD torsen in my TII)
you'll also need a special driveshaft to use a TII rear end with an NA trans (mazdatrix sells them), or just get a TII trans...
Also, you'll need S4 stub shafts for the rear end... S5 TII viscous stub shafts won't work on any aftermarket LSDs.
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM