Stuck intake manifold and leak
07-08-10, 10:51 PM
#1
Senior Member
Thread Starter
iTrader: (5)
Join Date: May 2010
Location: crater on mars
Posts: 476
Likes: 0
Received 0 Likes
on
0 Posts
Stuck intake manifold and leak
I am currently changing the intake manifold gasket cause there is a leak. Someone told me to use a hammer and a peice of wood to remove it but it was a fail 
Anyone have any suggestions on how to remove a stuck intake manifold? Are there only 4 screws on it? haha hopefully I didnt forget to remove a screw. btw white stuff would come out in between the intake mani and rotor housings. Coolant leak?
Peace
Anyone have any suggestions on how to remove a stuck intake manifold? Are there only 4 screws on it? haha hopefully I didnt forget to remove a screw. btw white stuff would come out in between the intake mani and rotor housings. Coolant leak? Peace
07-09-10, 01:05 AM
#2
Hide the pinball machine
iTrader: (2)
Join Date: Aug 2007
Location: Sammamish, wa
Posts: 461
Likes: 0
Received 0 Likes
on
0 Posts
Should not be hard at all to remove, certainly not requiring a hammer.
There are 4 bolts AND 2 nuts holding it on (5 bolts if its a turbo). The two nuts you appear to have forgotten are on the bottom, about halfway to the middle on each side.
There are 4 bolts AND 2 nuts holding it on (5 bolts if its a turbo). The two nuts you appear to have forgotten are on the bottom, about halfway to the middle on each side.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
