starts but goes straight to 5000 rpm then gets higher
#1
Full Member
Thread Starter
Join Date: Jan 2003
Location: san antonio, texas
Posts: 56
Likes: 0
Received 0 Likes
on
0 Posts
starts but goes straight to 5000 rpm then gets higher
it starts every time but it just shoots up and then stays there. i cant get it to come down. i messed with little things but still no success. fixin' to take it to the shop.
#3
Rotary Enthusiast
iTrader: (2)
Join Date: Sep 2001
Location: Altadena, CA
Posts: 932
Likes: 0
Received 0 Likes
on
0 Posts
Sounds like a BIIIIIIIIIIIIIIIIIIIIIG Vacuum leak I started my TII yesterday after forgetting to bolt the Upper intake manifold down (oops), and even then it only made it to 2000 rpm, so you've got something big happening Try what Aaron suggested and make sure the throttle plates can close all the way.
-Manolis
-Manolis
#4
Junior Member
Join Date: Jul 2002
Location: South Florida
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
i just had this problem last week when i finished put back together my engine. i had forgetten to put a lower intake gasket on and my car just shot str8 up to 4k+. after i changed the gasket it didnt do that, rather now it fluxuates between 800-1000 rpm, but i think that leak is from something else. its definately a big leak from an intake gasket.
#5
sounds like your throttle cable needs to be adjusted my friend. do what aaron said, and then start it. you can play with the throttle with the cable disconnected by flipping the swing arm on that controls the TB.
-scott
-scott
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM