Hello, i searched the FAQ and found almost the whole thing on my problem...except that my problem is that when i go to turn it on it turns then starts, dose it's 3k warm up jig, then kills over. but if i hold the gas it'll stay alive... like a idle air control sensor or somthing (i'm still tryin to learn all of the little knooks of these rotarys so bare with me, i'm trying my best.)
this problem happend while i was taking my a/c and heater box off discounecting all of the wires taht go to the HVAC box and lines for the a/c. on the heater box i just ran a longer hose from the engine to the port that goes to the radiator low side. i didnt mess with anything on the car's engine....since i'm not really doing anything other than deleting my A/C and heater setup.
can someone please help me get started in the right way, i'm always going one step back when i make progress! lol thanks for all the help in advance!!

 

Sounds like a vacuum leak. You might have bumped a vacuum line.

 

i'll take a look tommorw afternoon after the game and see if any lines are gone, thanks for the tip!!