Starting problem (searched, and i think i'm getting closer)
#1
Full Member
Thread Starter
iTrader: (4)
Join Date: Mar 2006
Location: Tulare, CA
Posts: 238
Likes: 0
Received 0 Likes
on
0 Posts
Starting problem (searched, and i think i'm getting closer)
so far these two threads have been the most help,
https://www.rx7club.com/showthread.p...ont+crank+over
and
https://www.rx7club.com/showthread.p...ont+crank+over
So far i've jumped the solenoid to the spade connector with a screw driver and manually turned the car over. I found out that my anti theft already had the large b/w and large b/g wires jumped, but the plug on the passenger speaker was not un-plugged. I've jumped the clutch safety switch with a wire. So i know it has to be the signal wire from the ignition and the connection on the harness is good, the only other thing i can think of is that it's inside the car where it is bad. does anyone else have any advice?
https://www.rx7club.com/showthread.p...ont+crank+over
and
https://www.rx7club.com/showthread.p...ont+crank+over
So far i've jumped the solenoid to the spade connector with a screw driver and manually turned the car over. I found out that my anti theft already had the large b/w and large b/g wires jumped, but the plug on the passenger speaker was not un-plugged. I've jumped the clutch safety switch with a wire. So i know it has to be the signal wire from the ignition and the connection on the harness is good, the only other thing i can think of is that it's inside the car where it is bad. does anyone else have any advice?
Thread
Thread Starter
Forum
Replies
Last Post