shimming the tie rods
#1
Banned. I got OWNED!!!
Thread Starter
Join Date: May 2004
Location: San Antonio
Posts: 778
Likes: 0
Received 0 Likes
on
0 Posts
shimming the tie rods
hey i have new tierod ends....i wanted to shim them like RETed said a whiles back to get some more angle......but i was uncertain how many or how far off i should shim them? thanx
#2
Lives on the Forum
You need to take the tie rod ends off of the steering rack.
It's not easy.
You'll need to remove the boots carefully - if you damage them, you need to replace them.
The twist wire ties can be reused, but they can be broken very easily.
After all of that, the front end needs to be realigned back to factory specs, so I hope the alignment shop is close by?
-Ted
It's not easy.
You'll need to remove the boots carefully - if you damage them, you need to replace them.
The twist wire ties can be reused, but they can be broken very easily.
After all of that, the front end needs to be realigned back to factory specs, so I hope the alignment shop is close by?
-Ted
Thread
Thread Starter
Forum
Replies
Last Post
joel(PA)
Group Buy & Product Dev. FD RX-7
8
10-04-15 06:07 PM
joel(PA)
Race Car Tech
0
10-01-15 10:25 AM