Shifting and rumbling problem
10-11-06, 04:29 AM
#1
Full Member
Thread Starter
Join Date: Sep 2006
Location: Northern Cali
Posts: 118
Likes: 0
Received 0 Likes
on
0 Posts
Shifting and rumbling problem
So i finally took my FC out for a spin after i changed the spark plugs, changed the belts, and the thermostat.
Whenever the clutch engages or put a load on the car by steppin on the gas, it makes kind of a clunk sound. and vibrations start at a certain speed.
So theres a shifting problem and a vibrating problem.
Can anyone tell me the problem here and the solution to it? Thanks.
Whenever the clutch engages or put a load on the car by steppin on the gas, it makes kind of a clunk sound. and vibrations start at a certain speed.
So theres a shifting problem and a vibrating problem.
Can anyone tell me the problem here and the solution to it? Thanks.
10-11-06, 07:04 PM
#2
Newbie
Join Date: Aug 2002
Location: Australia
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Had the same problem... turned out to be buggered clutch and rear gearbox mount sagged.... so... off it went for new clutch, got gearbox rebuilt, new gearbox mount and tail shaft remanufactured.... get it back in two days from now... $2000 aussie later hope it stops the prob.
10-11-06, 10:07 PM
#3
Full Member
Thread Starter
Join Date: Sep 2006
Location: Northern Cali
Posts: 118
Likes: 0
Received 0 Likes
on
0 Posts
gearbox mount = transmission mount?
im sorry, i dont understand that terminology, is that australian?
hm, can anyone else help me out with this problem? i dont want to just replace parts and hope it works.
im sorry, i dont understand that terminology, is that australian?
hm, can anyone else help me out with this problem? i dont want to just replace parts and hope it works.
Thread
Thread Starter
Forum
Replies
Last Post
The1Sun
1st Generation Specific (1979-1985)
7
09-18-15 07:13 PM
REX7&Z32TT
New Member RX-7 Technical
2
09-14-15 08:46 AM