Setting end float
Thread Starter
Joined: Oct 2002
Posts: 3,793
Likes: 1
From: Southern California
Setting end float
Okay,
I just swapped out the front cover of my TII motor (for a first gen conversion.)
After putting everything back together I notice that I have no end play in the flywheel. I checked the torrington bearing, and it appears fine. So, I do not think this is the problem. (Although it could be
)
What else can cause this problem? Can I add or subtract spacers to the "eccentric bolt" to adjust float?
Any suggestions, or help?
David
I just swapped out the front cover of my TII motor (for a first gen conversion.)
After putting everything back together I notice that I have no end play in the flywheel. I checked the torrington bearing, and it appears fine. So, I do not think this is the problem. (Although it could be
)What else can cause this problem? Can I add or subtract spacers to the "eccentric bolt" to adjust float?
Any suggestions, or help?
David
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM