Ok I just installed my SAFC II, but the throttle reading display is off. It says that at about 1/2 of the thottle opening, that it is at 100% throttle. Anybody know how to fix this problem?

 

that is normal on S4. 33% throttle = 100 on the Safc. that is the max of your TPS.

just set your low at 98% and high at 99% and it'll work fine.

 

If you have an S4 then its normal, actually should say full throttle at 1/3 of full throttle. No fix there, some suggest using the pressure sender as the input, do some searching you'll see it.

If its a S5 then there is something wrong, and hopefully someone more knowledgable could chime in.

Dan

 

Ok thanks. Is this messing anything up, or will it be ok to run around with it like that?

 

bump

Is the SAFC moddifying anything with the throttle position?

 

bump

Is the SAFC moddifying anything with the throttle position?

 

Some of us are considering running the throttle signal from the boost sensor. I think it would give a more accurate fuel curve. I see 100% throttle at about 1/3 pedal.

Jarrett

*edit* and your SAFC uses the throttle position to help determine correction.