SAFC, Blue wire for voltage
#1
Rotary Enthusiast
Thread Starter
Join Date: Dec 2001
Location: not in winterpeg anymore
Posts: 1,350
Likes: 0
Received 0 Likes
on
0 Posts
SAFC, Blue wire for voltage
okay, now my searching has lead me to understand that hooking up the blue witre from the SAFC to the wire coming out of the O2 sensor. This will supposedly give me a voltage reading.
Now, can I use the same wire coming out of the O2 sensor for both the A?F guage that it is already hooked up to, as well as having it hooked up to the SAFC.
And if I can, where on the SAFC do I monitor the voltage readings?
Now, can I use the same wire coming out of the O2 sensor for both the A?F guage that it is already hooked up to, as well as having it hooked up to the SAFC.
And if I can, where on the SAFC do I monitor the voltage readings?
#2
Former Rx7 *****
Join Date: Nov 2001
Location: Mississauga
Posts: 4,534
Likes: 0
Received 0 Likes
on
0 Posts
yes u can tap it into the o2 sensor wire or in your case the wire going to your AF gauge.
however it may cause drift of the voltage reading.
anyhow... to check the voltage... you scroll down to ETC. then goto number 4 i think and select sensor check.
IN2: is the voltage of the sensor. it will vary between 0V and 1.2 Volts
good luck.
Jason
however it may cause drift of the voltage reading.
anyhow... to check the voltage... you scroll down to ETC. then goto number 4 i think and select sensor check.
IN2: is the voltage of the sensor. it will vary between 0V and 1.2 Volts
good luck.
Jason
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM