2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

s4 slave cylinder question

Thread Tools
 
Search this Thread
 
Old May 5, 2008 | 08:24 PM
  #1  
vato2000taco's Avatar
Thread Starter
i hate donks!
Tenured Member 05 Years
iTrader: (1)
 
Joined: Oct 2006
Posts: 227
Likes: 0
From: waycross ga.
s4 slave cylinder question

how do i tell if slave cyl. is bad? my clutch is slipping all of a sudden at around 4g's and sometimes pedal is hard and high and sometimes pedal is soft and low as if air in slave cyl. is it bad or clutch time. what clutch should i use for about 350 hp on an s4 and what flywheel pro or street lite?thanks
Reply
Old May 6, 2008 | 05:10 AM
  #2  
InsomniacFC's Avatar
Will drive for parts
Tenured Member 15 Years
iTrader: (4)
 
Joined: Jun 2005
Posts: 1,252
Likes: 0
From: Modesto, CA
Bleed the system and get all that air out of there. Then check the master, slave, and soft line for leaks. There should not be any fluid leaking out of any of them. Since it is easy to spill a bit of brake fluid when bleeding the system, wipe up the excess and wait a day or two and then check for leaks again. If you see either of them are leaking they should either be rebuilt or replaced. The kits to rebuild them are about $20+ (a piece) on mazdatrix and $60+ to replace each of them.


The clutch slipping over 4k might be a sign that it's on it's way out or cannot handle the 350hp. You could always drop the tranny and do an inspection of the flywheel, clutch and pressure plate.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Nosferatu
2nd Generation Specific (1986-1992)
7
Sep 5, 2015 02:13 PM
Frisky Arab
2nd Generation Specific (1986-1992)
5
Sep 4, 2015 06:17 PM




All times are GMT -5. The time now is 10:18 AM.