s4 n/a lower intake on s5 block & vdi intake
#1
Rotary Enthusiast
Thread Starter
Join Date: Jan 2003
Location: fl
Posts: 1,255
Likes: 0
Received 0 Likes
on
0 Posts
s4 n/a lower intake on s5 block & vdi intake
ive been hearing that the s4 lower intake flows better than the s5 one.
would it be worth it to scrounge up a s4 lower intake and replace my s5 one with it? i if i did this i would most likely do some gasket matching and mild port and polishing on the entire intake track (tb on down).
what would i have to do to get the s4 intake to bolt onto the s5 block? anything? i know that id have to drill out the holes on the vdi section but thats not a big deal. anything else?
baisically i just want to know if it can be done and would it net any gains over the s5 lower intake.
always looking for that last little bit of n/a powah!
would it be worth it to scrounge up a s4 lower intake and replace my s5 one with it? i if i did this i would most likely do some gasket matching and mild port and polishing on the entire intake track (tb on down).
what would i have to do to get the s4 intake to bolt onto the s5 block? anything? i know that id have to drill out the holes on the vdi section but thats not a big deal. anything else?
baisically i just want to know if it can be done and would it net any gains over the s5 lower intake.
always looking for that last little bit of n/a powah!
Thread
Thread Starter
Forum
Replies
Last Post
KAL797
Test Area 51
0
08-11-15 03:47 PM