Running hot and maybe over heating
Thread Starter
Joined: Oct 2008
Posts: 200
Likes: 1
From: Alamogordo NM
Running hot and maybe over heating
so i start my 89 turbo and once it runs for a min or so the temp gauges goes as high as the needle will let it and the rad is hot i have a 3 in koyo rad and before it would run a little below 50% on the gauge
also im leaking a fair amount of oil on the turbo side of the engine it seems like its coming straight down from around the front of the turbo or maybe in that general area i would really like to potentially know what all could be the problem
also im leaking a fair amount of oil on the turbo side of the engine it seems like its coming straight down from around the front of the turbo or maybe in that general area i would really like to potentially know what all could be the problem
Joined: Sep 2005
Posts: 25,581
Likes: 136
From: Smiths Falls.(near Ottawa!.Mapquest IT!)
check your Coolant..see if it is LOW.
if it is top it up,,then Look for leaks,as it should not be low in the first place.
Oil in front of the Turbo..maybe the Oil line.(the steel one).
if it is top it up,,then Look for leaks,as it should not be low in the first place.
Oil in front of the Turbo..maybe the Oil line.(the steel one).
Thread Starter
Joined: Oct 2008
Posts: 200
Likes: 1
From: Alamogordo NM
its at the full level do you think its the thermostat i got a new one i will replace tomorrow if i can find out how
i will check on the steel line i think you might be right
also where is the thermostat at lol
i will check on the steel line i think you might be right
also where is the thermostat at lol
Thread Starter
Joined: Oct 2008
Posts: 200
Likes: 1
From: Alamogordo NM
oh is it under that black elbow thing? and i figured it was there
i messed around with it and i think its just leaking coolant and does coolant stain the ground
i messed around with it and i think its just leaking coolant and does coolant stain the ground
Thread
Thread Starter
Forum
Replies
Last Post
sherff
Adaptronic Engine Mgmt - AUS
9
Feb 24, 2019 12:09 PM



. 
