RX7Club.com - Mazda RX7 Forum

2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.
Sponsored by:
Banzai Racing

Rotor Bearing Install Question - Pic Inside.

Thread Tools
 
Search this Thread
 
Old 12-17-12, 01:42 PM
  #1  
Rotary Enthusiast

Thread Starter
iTrader: (9)
 
R-X-R's Avatar
 
Join Date: Jun 2011
Location: Syracuse,NY
Posts: 805
Received 4 Likes on 4 Posts
Rotor Bearing Install Question - Pic Inside.
I am trying to install new bearings on my rotors and i cannot get it to be flush.
is this good enough? i can feel a small lip with the figer. like 1mm. if i press more i am afraid i'm going to bend the tab on the bearing.



R-X-R is offline  
Reply Like
Old 12-17-12, 01:50 PM
  #2  
Sharp Claws

iTrader: (30)
 
RotaryEvolution's Avatar
 
Join Date: Oct 2003
Location: Central Florida
Posts: 5,107
Likes: 0
Received 41 Likes on 40 Posts
is it flush in the stat gear side of the rotor? if so leave it where it is.
RotaryEvolution is offline  
Reply Like
Old 12-17-12, 02:05 PM
  #3  
Rotary Enthusiast

Thread Starter
iTrader: (9)
 
R-X-R's Avatar
 
Join Date: Jun 2011
Location: Syracuse,NY
Posts: 805
Received 4 Likes on 4 Posts
kind of. like i said 1 mm lip
R-X-R is offline  
Reply Like
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Installed UIM gasket, now my engine won't run
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
Rear Brake Caliper issues on FB's
Marty RE
New Member RX-7 Technical
0
08-17-15 09:36 AM
Where to run aftermarket amp power?
gabescanlon
Interior / Exterior / Audio
1
08-11-15 05:59 PM
Back to Subforum
2nd Generation Specific (1986-1992)
View Next Unread
Alternator Questions.....




Advanced Search
Quick Reply: Rotor Bearing Install Question - Pic Inside.


Reply Closed Thread Share

All times are GMT -5. The time now is 11:24 PM.