Rims and Tires
#1
Full Member
Thread Starter
Join Date: Nov 2004
Location: Michigan
Posts: 106
Likes: 0
Received 0 Likes
on
0 Posts
Rims and Tires
For my vert (5 lug) I would like to go with an 18" rim. Was looking at the EXEL E-2.
For tires i would like to run AS wide as i can with 18" rim w/ say +40 offset what width of rim with those specs should i run in REAR, would like low profile tires of coarse, unless i plan on doing a lift for the 7! What width tire and aspect ratio.
What should i run up front with same offset and same rim height. (Tire width and aspect ratio as well as the width of the rim) Without any rubbing.
Thanks
For tires i would like to run AS wide as i can with 18" rim w/ say +40 offset what width of rim with those specs should i run in REAR, would like low profile tires of coarse, unless i plan on doing a lift for the 7! What width tire and aspect ratio.
What should i run up front with same offset and same rim height. (Tire width and aspect ratio as well as the width of the rim) Without any rubbing.
Thanks
#4
DONT FEED THE NOOBS
Join Date: Mar 2001
Location: land of slow hondas .... TULSA, OK
Posts: 1,270
Likes: 0
Received 0 Likes
on
0 Posts
doh i didnt even answer the question i run 215s up front and 225s no rubbing in the front with 17*7 (too small) i think the back allows you to get away with murder but you have to be very careful with the front.. i think if you are careful you can get a 225 in the front may have to watch your fender and get a really small spacer
Thread
Thread Starter
Forum
Replies
Last Post
rx7jocke
Suspension/Wheels/Tires/Brakes
72
06-17-16 03:48 AM