I did aauto to 5 sped swap on my 90 vert and i have no idea on how to conect the reverse lights can anyone help

 

I think reverse lights are in harness near shifter on auto (ties into the shifter itself) and on the manual near tailshaft I think you can just extend the wires from interior to tailshaft wires.

 

do you know wich color are they

 

This is from V8kilr's write up found at:

https://www.rx7club.com/showthread.p...hreadid=201073


Locate the two red wires on the manual transmission, keep them in mind.
Look for a white three pronged clip that used to plug into the automatic transmission, cut all three wires and connect the bottom two together "this will allow you to start the vehicle" and connect the top of the three to one of the red wires on the manual transmission "doesn’t matter which one, you will need to add some wire to complete the connection".

Now take the other red wire and run it into the inside of the vehicle through the shifter hole " you will need to add some wire to complete the connection" locate the wiring harness in the shifter area that used to connect to the automatic shifter assembly.

Locate the 4 pin clip, now locate the black with yellow stripe wire and attach it to the wire you ran inside the car from the transmission "this will allow your reverse lights to work".

Good Luck
ck