Remove or wire open 5th &6th ports
#1
Sit and Spin
Thread Starter
Join Date: Mar 2001
Location: Latrobe, Pa
Posts: 472
Likes: 0
Received 0 Likes
on
0 Posts
Remove or wire open 5th &6th ports
I have a S5 keg with S4 electronics and an S5 lower intake manifold with an S4 upper intake manifold.
I am wondering if I can / should just remove the 5th and 6th ports or should I wire them in place.
There is NO WAY I am getting them to function again. It is not worth it. The car is a race car and never sees less than about 3200 rpm.
Any help is appreciated.
Thanks,
Rob R.
I am wondering if I can / should just remove the 5th and 6th ports or should I wire them in place.
There is NO WAY I am getting them to function again. It is not worth it. The car is a race car and never sees less than about 3200 rpm.
Any help is appreciated.
Thanks,
Rob R.
#3
Rotary Enthusiast
Join Date: May 2003
Location: chicago land
Posts: 998
Likes: 0
Received 0 Likes
on
0 Posts
Either way works fine for your purpose but I would recommend getting the inserts to help with flow. You will not notice a difference between removing them or having them open at all times, I have heard good things about the inserts though.
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM